The Gorman conversion method is a Lab L channel based method. It combines L channel conversion with masked solid layer toning and high pass filter sharpening. Because it ignores color information, this method works better on images that have little color to begin with.
Lab color mode is a mode in Photoshop. Lab is different from RGB color mode in that it separates the luminosity information into it’s own channel. Lab mode has three channels: L, a and b.
The L Channel contains the image’s luminosity information. This allows you to manipulate the image’s luminosity without affecting it’s colors. The L channel is similar to black and white film in that it only records the image’s luminosity.
Continue reading Lab Color Mode
Grayscale mode is a color mode in Photoshop. In grayscale mode, images are represented using only shades of gray rather than the full pallet of colors.
In RGB mode, the color of each pixel is stored as three numbers, or channels (nnn, nnn, nnn). If all three channels have the same value then the resulting color is a shade of gray.
|Gray (80, 80, 80)|
|Gray (160, 160, 160)|
|White (255, 255, 255)|
What is the difference between monochrome, black and white, and grayscale? The three terms are often used interchangeably, but there are technical differences.
Hand-coloring has been used by photographers for over a century to add color to black and white photographs. This was done by hand painting the photograph with oil or watercolor paints. Unlike toning, which applies the same color to the entire image, selective coloring applies one or more colors to specific parts of the image.
The usual way to apply selective color is to use a mask and a solid color layer to apply color to specific parts of the image. However, by using Color Range selection and curves, you can create a more subtle look.
RGB (Red, Green, Blue) is a way of describing color. Each color is described by a set of three numbers. For example, (102, 51, 255) describes THIS COLOR.
The color’s RGB value, written (n, n, n), describes the intensity of the red, green, and blue channels that make up that color. The range of values for each channel depends on the channel’s bit-depth, or how many bits are used for each channel.
|8 bit||0 – 255|
|16 bit||0 – 32768|
|32 bit||0.000 – 1.000|
For example, in an 8-bit RGB each channel can have a value from 0 to 255. Zero means no brightness for that channel, 255 means maximum brightness. 8 bit RGB colors can range from (0, 0, 0) to (255, 255, 255) and every combination in between, or 2563 = 16,777,216 different colors.
Note that a 32 bit RGB should have an integer range between 0 and 232-1 or 4,294,967,295. However, this is normalized to a decimal value between 0.000 and 1.000.
There used to be only two ways to create black and white digital photos: either set your camera to black and white and take a picture, or use expensive photo editing software. Both methods left something to be desired, either in terms of poor quality or high cost.
Today there are more options for creating great looking black and white digital photos.